View more Honda Car Repair topics here.

I think my CV Joint is so bad that it is making a very very loud noise. How will i know if its

damaged? How much would it cost to replace them a 2000 Honda Civic in Houston? Please assist I dont know what steps to take. What causes that? Is it something major? If you dont replace them, what would happened? Please assist I dont know what steps to take and I truly dont know anything about cars. I appreciated very much.
Read more on this topic

which side needs the cv axle repaired?

i've a 1989 honda prelude 4ws i recently bought it. the owner said it needs a new cv axle however i dont remember which side, what is a great way to discover which side needs fixing with no needing to ask the previous owner? oh and the steering is also hard do i need a new steering pump? any advice is appreciated thank you
Read more on this topic

2004 Accord Ex - cv joints already?

I recently noticed that my 2004 accord will sometimes make a crick-crick-crick-crick sound when creating left hand turns, however just when it is cold (it is been 17-25f here all week) It only began in the middle of the week. If I did not know any better, I would nearly say it sounds similar to a cv joint/boot, a typical problem in older Hondas. however, the strange thing is that this noice goes away once the car is warmed up. Any ideas?
Read more on this topic

Is it ok to drive without CV boots on 96 Honda Accord?

I've a 96 Honda Accord Ex. My mechanic told me my front CV boots were gone however I could still drive it with no difficulties until I hear my axles clicking while I'm turning. I was wondering how does driving with no CV boots affect overall driving and performance? On a related note, I'm taking a 600 mile road trip in a month or so. What kind of things ought to I do to my car to prepare it?
Read more on this topic

What do I have to disconnect/take off to change my cv boot on my 1989 Honda Accord LXI?

I must adjust my right side cv boot and I sought to know what it entails? Do I only need to take away the wheel, or do I need to dismantle the control arms and sway bar, take away the rotor and brake caliper, and more things I haven't ever done prior to and most likely dont have tools for? If somebody has done this job prior to or knows the solution, your advidce would be greatly appreciated.
Read more on this topic